USDTUSDTUSDT (ERC-20) → USDT (BEP-20)
Exchange USDT (ERC-20) to USDT (BEP-20)
1 USDT ≈ 0.985 USDT · min 13.2994 USDT
Indicative rate. Your exact rate locks in the form below.
Same dollar, cheaper network. Move USDT off Ethereum without the gas on every transfer.
Send USDT on the Ethereum network, receive USDT on the BNB Smart Chain at your own address. We lock the rate the moment you start: what you see is what lands.
How to exchange USDT (ERC-20) to USDT (BEP-20)
- 01 Enter the amount and your USDT address on the BNB Smart Chain (BEP-20).
- 02 Send USDT on the Ethereum network (ERC-20) to the address shown, in one transaction.
- 03 Receive USDT on the BNB Smart Chain, at your address, usually quickly.
Examples: USDT → USDT at the current rate
Indicative rate — the exchange form locks the exact amount.
Done paying Ethereum gas
Once your USDT sits on the BNB Smart Chain, every future transfer costs a fraction of Ethereum. No more holding ETH just to move dollars.
No market risk
Both sides are the same dollar, so you are not betting on price, you are changing networks. The amount you land on is locked before you send.
We check the address before you send
ERC-20 and BEP-20 formats differ even though both start with 0x. We only show deposit details for an address on the right network, catching the common mistake.
Your coins do not sit with us
We do not hold a balance. USDT comes in and goes straight out as BEP-20 to your address.
USDT on Ethereum and USDT on BNB Chain are the same dollar but two different assets on-chain, and their addresses are not interchangeable even though both start with 0x. Send on the Ethereum network (ERC-20), and give a receiving address on the BNB Smart Chain (BEP-20). To move USDT onward on the BNB Smart Chain, the wallet needs a little BNB for gas. The swap goes through after Ethereum network confirmations. After the move every onward dollar transfer costs a fraction of what it did, though the fuel changes too: the new wallet needs BNB rather than ETH. The dollar itself is unchanged; what changes is the network holding it. Take the receiving address from a wallet you hold the keys to and check the network in it before pasting. The exact rate and minimum are shown right in the swap form. The exchange starts after 12 confirmations on Ethereum — usually about 3 min.
How we differ
Comparing us with a specific service? Read the sourced, dated breakdowns
FAQ
Do I need an account or documents to move to BEP-20?
No. The amount and your USDT address on the BNB Smart Chain are enough. We do not check the person swapping and collect no paperwork. The screening applies to the funds: if an incoming payment cannot be cleared, the deposit returns to the sender address, which you control.
Why move from ERC-20 to BEP-20?
Transfers on the BNB Smart Chain cost far less than Ethereum gas. If you plan to move dollars often, this is cheaper. Holding USDT once is fine on any network; it is the frequent transfers on Ethereum that add up.
Why is the figure at the end not the one I sent?
Moving between networks is not free. You lock the exact rate before you send, and it does not change after that. The dollar stays a dollar: what you pay for is the change of network, not a change of asset.
How long does the move onto the BNB Smart Chain take?
Count from Ethereum confirmations: until the deposit confirms the swap does not start, and that is most of the pause. The pace follows network load, steady when it is quiet and slower when it is busy. The BNB Smart Chain payout follows right after, and the status shows the step.
Where does the USDT arrive, and how do I not mix up the addresses?
It arrives on the BNB Smart Chain, BEP-20 standard. Both addresses start with 0x but the networks differ: send USDT on Ethereum and give an address your wallet issued for the BNB Smart Chain. If it arrives wrong, message @swappsy.
What if the amount that lands is not the one on the order?
The order is recalculated from the sum that actually confirmed at the address, at the rate in effect then, and the updated total shows in the status. Unusual cases, such as a transfer sent in several parts, go to manual review and support @swappsy finishes them with you.
How do I get the money back if the swap cannot happen?
Put a refund address on the order and the USDT goes back there if the swap cannot be completed. Fill it in before you send, and the return needs no extra approvals.
Which network do I send USDT on?
Exactly the one this page names: USDT (ERC-20). A transfer on a different network, or sent to the token's contract address, cannot start this exchange — those cases go through manual support review.
What is the minimum amount?
Right now this direction starts from about 13.2994 USDT. The exchange form shows the exact minimum — it follows the live rate.
Page reviewed: